
IG052714-1.0
1.877.817.6028
www.DiodeLED.com
INSTALLATION GUIDE
®
LIGHTTOUCH™ DIMMER SWITCH
Troubleshooting
Operation
On/O
Tap anywhere on the aluminum body to toggle On/O.
Increase Brightness
Hold nger to aluminum body unl brightness increases to desired level.
Decrease Brightness
Hold nger to aluminum body unl brightness decreases to desired level.
Fixture does not
illuminate
• Verify the system is wired correctly & ensure polaries are correct.
• Ensure the driver and xture have the same voltage speciaons (12V &
12V, or 24V & 24V).
Fixture illuminates,
dimmer controls are
unresponsive
• Verify the following connecons & ensure polaries are correct: Driver
Output is connected to Dimmer Input; Dimmer Output is connected
to LED Load. If the driver is connected to the Dimmer Input than the
dimmer controls will not funcon properly.
Fixture is consistently
ashing or ickering
• Ensure no more than a single dimmer is aached to each driver output.
• Verify a compable constant voltage driver is installed.
• Ensure a compable constant voltage dimmable xture is installed.
Fixture is inconsistently
ashing or ickering
• Verify all connecons are properly secured. Ensure all accessories are
properly connected.
Fixture is slowly
ashing
• Ensure driver is not overloaded. An overloaded driver will cause the internal
auto-reset of the driver to trip repeatedly.
Shi in brightness of
xture array
• Verify the appropriate size wire gauge (AWG) has been installed. See the
‘Tools & Resources’ page at www.DiodeLED.com for Voltage Drop Charts.
• Ensure xture length is not exceeding maximum run limit.
Driver is buzzing
• Verify the constant voltage driver is compable with compable
with PWM controls. See the driver specicaon sheet and check the
‘Dimmability’ secon.
QUESTIONS?
Visit www.DiodeLED.com or contact Customer Support at info@DiodeLED.com
or 1.877.817.6028 Monday through Friday, 7:00am - 5:00pm PST.
Comentários a estes Manuais