1.877.817.6028
www.DiodeLED.com
INSTALLATION GUIDE
1 OF 4
DAZZLE 24
™
24V RGB LED TAPE LIGHT
®
Do not bend LED strip light on a
horizontal plane.
Do not fold or crease LED strip light.Do not bend LED strip light to a diameter
less than 1.5 inches.
Do not put excessive pressure on surface of
strip light (e.g. glass/acrylic panes etc.).
1.5 in.
Do not cover strip light with any materials. Do not power strip light while
aached to spool or ghtly coiled.
• Install in accordance with the Naonal Electric Code and local
regulaons.
• This product is intended to be installed and serviced by a qualied,
licensed electrician.
• DO NOT connect tape directly to 120VAC power.
• To meet the tape ETL Lisng cercaon, tape light must be powered
with a compable Class 2 DC constant voltage LED driver (power
supply).
• Each LED driver is unique and may require a proper load derang,
which is dependent to the installed ambient temperature environment.
Refer to each driver specicaon sheet for full power rangs & load
derangs.
• Do not power tape light while aached to plasc spool or ghtly coiled.
Excess heat may melt the spool and/or cause damage to the tape.
• Do not install tape light in direct sunlight.
• Ensure applicable wire is installed between driver, xture, and any
controls in between. When choosing wire, factor in voltage drop,
amperage rang, and type (in-wall rated, wet locaon rated, etc.).
Inadequate wire installaon could overheat wires, and cause a re.
• Tape light, aached wire leads, and addional extension cables,
connectors, etc., are not rated for in-wall installaon unless otherwise
noted. Connectors have a Class 2 amp limit unless otherwise noted.
• Tape light must be handled with care. Excessive handling, bending, and
pressure may damage the product, voiding the warranty.
• Each tape light has a dierent power consumpon rang and maximum
run length that must be individually wired to a compable low voltage
(PWM) control or DMX decoder. Refer to the tape light packaging label
or specicaon sheet for further technical informaon.
Safety & Warnings
Tape Light Handling
DO NOT CONNECT
Quick Specs
Included Model(s)
DI-24V-DRGB-0016
DI-24V-DRGB-W016
Ambient Temperature † -4° ~ 122°F (-20° ~ 50°C)
Environment Dry / wet locaon (model dependant)
Input Voltage 24VDC constant voltage
Power Consumpon
4.32W / 180mA per foot
For full specicaons, see the ‘Specicaon Sheet’ available at the online
product page.
†
Do not install product in an environment outside the listed ambient
temperature. Ensure adequate airow and heatsinking is considered
when mounng/installing.
DO NOT CONNECT DIRECTLY TO HIGH VOLTAGE POWER!
Read all warnings and installaon instrucons thoroughly.
WARNING
IG082514-2.4
Comentários a estes Manuais