3 of 4
INSTALLATION GUIDE
RGBW ZONE COLOR CONTROLLER
IG022614-1.0
No. Press to Switch Color
Press to Switch Dynamic Mode
Skip Fade Strobe
1 No Color (use when creang custom scene) N/A N/A N/A
2
Red Stac Red Red fade in/out Red strobe
3 Green Stac Green Green fade in/out Green strobe
4 Blue Stac Blue Blue fade in/out Blue strobe
5 Yellow Stac Yellow Yellow fade in/out Yellow strobe
6 Purple Stac Purple Purple fade in/out Purple strobe
7 Cyan Stac Cyan Cyan fade in/out Cyan strobe
8 White Stac White White fade in/out White strobe
9 Red, green, blue RGB Skip RGB fade in/out RGB strobe
10 Red, green, blue, yellow, purple, cyan, white 7 Color Skip 7 Color fade in/out 7 color strobe
Zone Remote Operation Continued
Mode Chart
W
BGR V+
Output
DC+ DC−
PowerAddress
Seng
NUR
Input From
5-24VDC Driver
Learning ID
Running Light
To Low Voltage
LED Load
White Light Indicator
RGB Color Indicator
RGBW Zone Receiver
Wiring Connections
Troubleshooting
Fixture does not illuminate
• See ‘System Diagram’ and installaon guides of all components. Ensure the system is wired correctly.
• Verify polaries are correct.
• Ensure a compable constant voltage dimmable xture is installed.
• Ensure a compable constant voltage driver is installed.
• Ensure the driver and xture have the same voltage speciaons (12V & 12V, or 24V & 24V).
Fixture does not dim
• Ensure a compable constant voltage dimmable xture is installed.
• Ensure desired zone is selected before changing brightness.
RGB colors dims but do not turn o • This is normal. RGB colors may be dimmed to lowest brightness if white color is ulized.
Fixture is ashing or ickering
• Verify a compable constant voltage driver is installed.
• Ensure a compable constant voltage dimmable xture is installed.
• Ensure all connecons are properly secured.
• Ensure a dynamic mode (skip, fade, strobe) is not running.
• Ensure no more than a single controller is aached to each driver output.
Fixture is slowly ashing
• Ensure driver is not overloaded. An overloaded driver will cause the internal auto-reset of the driver
to trip repeatedly.
Correct colors are not illuminang
• Verify the correct leads are connected to the correct terminals on the receiver.
• Ensure potenal leads at opposing end of xture are not crossed.
Unable to pair remote with receiver
• Ensure the remote is fully charged.
• Read the installaon instrucons on page 1 thoroughly.
• Reset the remote and receiver(s) to factory sengs.
Prior to troubleshoong, ensure a compable system is installed. Verify compable xtures, drivers, controls and addional components were specied
correctly.
Determine the number of low voltage outputs of the driver when installing mulple PWM controllers. No more than one PWM controller can be aached to
a single output of the driver.
(2 páginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais