Diode-led OMNIDRIVE Manual do Utilizador descarregar pdf (Página 4)

1.877.817.6028

www.DiodeLED.com

[email protected] www.DiodeLED.com

INSTALLATION GUIDE

4 OF 4

OMNIDRIVE™ ELECTRONIC DIMMABLE DRIVER

IG071014-1.1

Additional Resources

Visit the online product page at www.DiodeLED.com for addional product specicaons & warranty informaon.

• OMNIDRIVE Specicaon Sheet

For full specicaons.

• OMNIDRIVE / Control Compability List

For compable dimming controls.

• Voltage Drop Charts

Use to specify appropriate wire gauge for installaon. Available at the ‘Tools & Resources’ page at www.DiodeLED.com.

Fixture does not illuminate

• See ‘System Diagram’, ‘Wiring Connecons’ and installaon guides of

all components. Ensure the system is wired correctly and polaries are

correct.

• Ensure a compable constant voltage dimmable xture is installed.

• Ensure the driver and xture have the same voltage specicaons

(12V & 12V, or 24V & 24V).

Fixture does not dim

• Ensure a compable constant voltage dimmable xture is installed.

• Ensure a compable dimming control is installed and wired correctly.

See ‘OMNIDRIVE / Dimmer Control Compability List’.

Dierent xture types do not dim in sync

• Dierent xture types have dierent circuit designs and may react

dierently when dimmed. Ensure each xture type is installed on a

separate dimmable driver for best performance.

Fixture is quickly ashing or ickering

• Verify a compable dimming control is installed. If ickering is apparent

at low light levels install a compable trim-adjustable dimming control.

• Ensure a compable constant voltage dimmable xture is installed.

• Ensure dierent xture types are not connected to a single driver.

Dierent xture types must be connected to individual drivers.

• Ensure all connecons are properly secured.

• Ensure xture is receiving the correct input voltage.

Fixture is slowly ashing

• Ensure driver is not overloaded. An overloaded driver will cause the

internal auto-reset to trip repeatedly.

Installaon Trips Main Breaker

• Check wiring for short circuit. If breaker connues to trip there may be

a short in the driver. Call customer support for a replacement driver.

Troubleshooting

QUESTIONS?

Visit www.DiodeLED.com or contact Customer Support at inf[email protected]om

or 1.877.817.6028 Monday through Friday, 7:00am - 5:00pm PST.

1 2 3 4

Comentários a estes Manuais

Sem comentários

Diode-led OMNIDRIVE Manual do Utilizador Página 4

Comentários a estes Manuais

Manuais e produtos relacionados com Iluminação Diode-led OMNIDRIVE