1.877.817.6028
www.DiodeLED.com
INSTALLATION GUIDE
3 OF 4
RGB ZONE COLOR CONTROLLER
®
Mode Description Chart Wiring Connections
No. Mode
1 3 colors changing
2 7 colors changing
3 White ash
4 7 colors ashing
5 RGB fade in/out
6 Red/Green fade
7 Red/blue fade
8 Green/blue fade
9 Red/yellow fade
10 Green/cyan fade
11 Blue/purple fade
12 Green/yellow fade
13 Blue/cyan fade
14 Red/purple fade
15 Blue/white fade
16 Yellow/purple/cyan fade
17 RGB
18 Full color fade
DO NOT connect directly to 120VAC.
Install in accordance with the NEC,
and local regulaons.
DC+
DC-
V+
B
G
R
RF
Input from 12-24V
LED Driver
To Low Voltage
LED Load
Zone Remote
Zone Receiver
Troubleshooting
Fixture does not illuminate
• See ‘System Diagram’ and installaon guides of all components. Ensure the system is wired correctly.
• Verify polaries are correct.
• Ensure a compable constant voltage dimmable xture is installed.
• Ensure a compable constant voltage driver is installed.
• Ensure the driver and xture have the same voltage specicaons (12V & 12V, or 24V & 24V).
Fixture does not dim
• Ensure a compable constant voltage dimmable xture is installed.
• Ensure desired zone is selected before changing brightness.
Fixture is ashing or ickering
• Verify a compable constant voltage driver is installed.
• Ensure a compable constant voltage dimmable xture is installed.
• Ensure all connecons are properly secured.
• Ensure no more than a single controller is aached to each driver output.
Fixture is slowly ashing
• Ensure driver is not overloaded. An overloaded driver will cause the internal auto-reset of the driver
to trip repeatedly.
Correct colors are not illuminang
• Verify the correct leads are connected to the correct terminals on the receiver.
• Ensure potenal leads at opposing end of xture are not crossed.
Unable to pair remote with receiver
• Ensure the remote is fully charged.
• Read the installaon instrucons on page 2 thoroughly.
• Reset the receiver(s) to factory sengs.
Receivers unintenonally sync together
• If receivers are not paired to a remote, they may unintenonally sync together. To de-sync receivers
see ‘Reseng Receivers to Factory Sengs’ on page 2.
Prior to troubleshoong, ensure a compable system is installed. Verify compable xtures, drivers, controls and addional components were specied correctly.
IG060914-1.2
(2 páginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais